Spo2 Simulator
OxSim - Pulse Oximetry Tester
|
The
OxSim is the perfect complement to the SimCube family. It is Optical
tests the whole system, including the sensor, pocket sized and runs on
one AA alkaline battery for 10 hours 4 Oxygen saturations, 3 pulse
rates and a low perfusion mode all at the touch of a button make it an
indispensable tool for any biomed. OxSim is small enough to fit right
into your SimCube carrying case and can be run off the same battery
boost option as your SimCube, simultaneously
|
|
|
 |
 |
 |
A
single Mode button toggles between modes with different saturation
values, different heart rates, and different perfusion levels. |
|
A
single probe Type button toggles through R-curves for different brands
of oximeter probes, though most are automatically detected by OxSim. No
complicated software menu to navigate, searching for ma |
|
Small enough to fit in your shirt pocket. Dimensions: 2-1/4 X 2-1/2 X 1-1/4 not including finger section |
|
Provides 8 hours of continuous simulation time on a single AA battery. |
|
Optical
simulation means there are no adapter cables to purchase or carry, and
that you test the whole system, including the sensor. |
|
Tested for ruggedness--over 50 drops with no failures |
|
|
|
Simulation Accuracy
Saturation Error
Error
in the displayed saturation value should be less than or equal to the
specified error of the sensor which is typically +/- 2%, but which can
be +/-3% or more for some disposable sensors.
Heart Rate Error
Less than 1 bpm
Modes of Operation
85%
Saturation 85%
Pulse Rate 80 bpm
Perfusion Index 2.0
95%
Saturation 95%
Pulse Rate 40 bpm
Perfusion Index 2.0
98%
Saturation 98%
Pulse Rate 80 bpm
Perfusion Index 2.0
140 BPM
Saturation 98%
Pulse Rate 140 bpm
Perfusion Index 2.0
Low Perfusion
Saturation 99%
Pulse Rate 80 bpm
Perfusion Index 0.2
Sensor Type Selection
Nell/Mas Used for:
All
Nellcor, Masimo, Datascope, Protocol, Spacelabs, HP/Philips (blue
extension cable), HP/Philips (tan soft sensor), Nihon Kohden, Colin,
GE/Marquette, Welch Allyn
HP/Ohm Used for:
HP cocoa brown soft sensor, Ohmeda and Novametrix
|
Physical Dimensions
Size
2.5'' x 2.5'' x 1.25'' (excluding finger)
Weight
5 ounces (excluding battery)
SpO2 Connection
Optical
Power Battery
1 AA battery (any chemistry)
Power Battery Life (Alkaline)
8 to 10 hours of simulation time (typical, depending on the oximeters under test)
60 days in sleep mode (unit sleeps after 10 min. with no probe connection)
AC operation
Included 6V DC supply operates over 100-240 VAC, 50-60 Hz
|
|
|
 |
|
 |
